Silicone Removal & Re-application

Remove deteriorated silicone and renew joints around showers, basins or other suitable fittings.

About the service

Old silicone can discolour, lift away or split where materials meet. Re-application involves removing loose or deteriorated sealant, preparing the joint and applying fresh silicone where suitable. Photos can show the joint length, adjacent materials and any visible gaps.

Where it can help

  • Lifting or split silicone around a shower
  • Discoloured joints at the edge of a basin or worktop
  • Existing silicone that needs removal before renewal

How to discuss the work

  1. Show the full joint

    Send an overview and close-ups of separation, gaps or discolouration.

  2. Describe room use

    Identify the fixtures and mention whether the affected joint gets wet regularly.

Joint location and visible gaps

Show a continuous view of the joint and where it meets a corner. Explain if sealant has separated on one side or if dark marks sit beside the joint. Describe any recurring moisture around the fixture.

Another service to consider

If the surrounding tiles or fittings also need cleaning, review the bathroom cleaning scope.

Bathroom Cleaning

When should I enquire about replacing a silicone joint?

Share close-ups if the bead is lifting, split or missing at a corner. If moisture appears nearby, describe its location and frequency so the joint can be discussed in context.

Show where the joint begins and ends

Identify whether it runs around a sink, bath, shower enclosure or another fitting. Note its approximate length and whether work is needed across multiple fixtures.

What to check before you enquire

Look for the type and extent of failure

Check how the bead meets the fixture and surrounding finish. Report whether it has pulled away along one edge, has a gap at a corner, or is split across a longer length. A close photo can show the gap, while a wider view will identify the fixture and the route of the joint. Include a rough length if you can estimate it.

Identify the materials at the joint

A joint can meet glass, tile, metal, a vanity, or the rim of a fitting. Show each side in your photo and mention if one part is natural stone. Note if the surrounding finish has stains or chips that are also a concern. If the joint is difficult to see behind a fixture, point out which parts are accessible from the front.

Distinguish the seal concern from ongoing moisture

If dampness comes back after the area has dried, explain when and where it returns. Mention whether it is around the joint, below a fitting, or appears elsewhere in the room. This information gives context for discussing a new bead alongside any source of water that may need separate attention. A dated photo can help when the issue is intermittent.

Map every fixture included in the enquiry

List each bath, sink, shower, or other fitting with the location of its affected joint. A joint along a single vanity and work around several wet areas have different scopes. Mention if an adjoining tile edge has also been damaged or needs cleaning. If the current bead has a color you want to match, show it in daylight and describe your preference.

Put the scope into one message

Share close-ups of the old silicone and identify each joint you want renewed. Add your area in Dubai and say which part of the work you want to discuss first. You can review the message and attach images in WhatsApp before sending.

Start a silicone removal & re-application enquiry
Chat on WhatsApp