Home / Products / Deep Groove Ball Bearings

Deep Groove Ball Bearings

The workhorse. Radial loads, high speed, sealed or shielded.

6000 · 6200 · 6300 · 6800 · 6900 series

Overview

The single most requested bearing over our counter. A deep groove ball bearing carries radial load and a useful amount of axial load in both directions, runs at high speed and needs no maintenance once it is sealed and greased. If a motor, pump, fan or gearbox has failed, this is almost always the part in your hand.

What we stock

Metric 6000, 6200, 6300, 6800 and 6900 series
2RS sealed, ZZ shielded and open variants
C3 clearance for electric motor and high-temperature duty
Stainless and non-standard sizes to order

Variants and suffixes

2RS — rubber sealed both sides
ZZ — metal shielded both sides
C3 — increased internal clearance
Open — no seal or shield

Typical applications

Electric motors
Water and chemical pumps
Exhaust and HVAC fans
Gearboxes and drive shafts
Conveyor idlers
Workshop machinery

Why buy this here

We buy direct from our manufacturing partners, so the counter price on standard sizes is set at the factory end rather than after three local margins. Stock sits in Dragon Mart 1 twelve hours a day, six days a week, and single pieces are sold on the same terms as carton quantities.

If you are not certain which variant you need, send a photograph of the failed part to our WhatsApp. The markings on the outer ring — or, failing that, the bore, outside diameter and width — are enough for us to identify the correct replacement.

Areas we serve

Collection from Dragon Mart 1, International City. We regularly supply workshops across Dubai, Sharjah, Ajman, Abu Dhabi and Al Ain, and arrange courier delivery within the UAE.

Common questions

2RS has a contact rubber seal on both sides — better at keeping dust and water out, slightly more friction. ZZ has a metal shield on both sides — less friction and better at higher speed, but not as good against washdown or fine dust. For most workshop and outdoor jobs in the UAE, 2RS is the safer choice.

C3 gives more internal clearance than standard, which the bearing needs when the shaft or housing runs hot and the inner ring expands. Electric motor rebuilds and anything running continuously in the heat usually call for C3.

Yes. Bring the failed part or send a photo of the markings on the outer ring to our WhatsApp. If the number has worn off, we can identify it from the bore, outside diameter and width.

On the shelf